Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Front Wheel Hub Bearing Replacement

Model: BMW X3 E83, MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Bearing

See other generations:
Video tutorial

To perform this maintenance, position the vehicle on a lift and remove the front wheel, the complete brake caliper with its bracket, and the brake rotor. Disconnect the tie rod end from the steering rack and the suspension control arm to free the hub support.

Remove the speed sensor, the bolt securing the shock absorber to the hub support, and extract the axle to completely free the support. Use a bushing and a hammer to extract the hub from the support, detach the retaining ring that secures the bearing, and remove the outer flange.

Then, place the support under a hydraulic press to extract the old bearing and insert the new one, then apply the retaining ring, the flange, and press the hub back into place using the press. Once the assembly is complete, reverse the steps for installation back onto the vehicle.


Updated on 15 February 2026 by ScegliAuto


Related tutorials

Replace Front Brake Pads on BMW X3
BMW X3 (2003-2010 / E83, MK 1) Are the front brake pads due for replacement? Here’s how to change them on a BMW X3. Lift the vehicle on a column lift to a comfortable height, then …
Steering Rack Tie Rod End Replacement
Steering Rack Tie Rod End Replacement
BMW X3 (2003-2010 / E83, MK 1) To replace the tie rod end of the steering rack, lift the vehicle on a hydraulic lift and remove the front wheel; then start by loosening the lock nu…
How to Remove and Replace the Rear Brake Rotor on a BMW X3
How to Remove and Replace the Rear Brake Rotor on a BMW X3
BMW X3 (2003-2010 / E83, MK 1) Let's see how to remove and replace the rear brake rotor on a BMW X3. First, lift the vehicle on a column lift to the desired height. Next, remove th…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos