Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Serpentine Belt on the BMW 3 Series 330i

Model: BMW Serie 3 E46 - Years 1998-2006
Part: V-belt

In this brief and simple guide, see how to remove and replace the serpentine belt on the BMW 3 Series 330i by following the instructions below. First, lift the vehicle and begin by removing the lower plastic engine cover by unscrewing all the screws; then remove the plastic cover located behind the front bumper, also disassembling the fan (disconnecting the electrical connector), as shown in the video. At this point, loosen the tensioner with a Torx wrench and remove and replace the serpentine belt with the new one!

Updated on 3 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Instructions for Disassembling the Camshaft on BMW 3 Series 330i E46
Instructions for Disassembling the Camshaft on BMW 3 Series 330i E46
BMW Serie 3 (1998-2006 / E46) In this video, you will see how to disassemble the camshaft from the cylinder head on a BMW 3 Series 330i E46; in this case, we will only cover the s…
How to replace the cabin fan of the BMW 3 Series 330i
How to replace the cabin fan of the BMW 3 Series 330i
BMW Serie 3 (1998-2006 / E46) Today's main instructions will show us how to disassemble and replace the blower motor of the BMW 3 Series 330i. First, we open the car's hood and lo…
How to Reset the Service Light on the 2003 BMW 330i
How to Reset the Service Light on the 2003 BMW 330i
BMW Serie 3 (1998-2006 / E46) In this new mini guide for your 2003 BMW 330i, we will discover how to correctly perform the manual reset of the service light that continues to illu…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos