Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Coolant in a BMW 1 Series

Model: BMW Serie 1 E81, E82, MK 1, E87 - Years 2004-2013
Part: Antifreeze coolant

This guide outlines the steps to bleed and replace the coolant in a BMW 1 Series. First, lift the vehicle and disconnect the coolant hose by loosening the clamp screw; let the fluid drain into a container for about ten minutes. At this point, reconnect the hose and unscrew the cap of the antifreeze reservoir to top up; use the appropriate fluid for your radiator, filling to the maximum level indicated on the reservoir!

Updated on 17 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Radiator Fluid on a BMW 1 Series
How to Replace the Radiator Fluid on a BMW 1 Series
BMW Serie 1 (2004-2013 / E81, E82, MK 1, E87) Do you want to replace the coolant? Here’s how to top up the fluid on a 1 Series. Pull the plastic lever located at the bottom left of the dashboard,…
How to replace the temperature sensor on the BMW 1 Series
How to replace the temperature sensor on the BMW 1 Series
BMW Serie 1 (2004-2013 / E81, E82, MK 1, E87) Here is a brief procedure for removing and replacing the coolant temperature sensor on the BMW 1 Series. First, open the bonnet and start by removing…
Guide to Removing the Engine on the BMW 1 Series F20 M135i
Guide to Removing the Engine on the BMW 1 Series F20 M135i
BMW Serie 1 (2011-2019 / MK 2, F20, F21) In this video tutorial, you will find the main instructions for removing the engine from the BMW 1 Series F20, in the M135i version. First, open the …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos