Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Front Bumper

Model: BMW Serie 3 E46 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Front bumper

See other generations:
Video tutorial

To remove the front bumper, you must first take off the front turn signal and the headlight. Locate the hole on the edge of the fender where you can insert a screwdriver to unscrew the turn signal mounting screw.

Then detach the trim located just below the headlight before moving on to the four headlight mounting pins. Repeat the same operation on the other side.

Next, unscrew the screws that secure the lower edge of the bumper to the splash guard and the pins located centrally, perpendicular to the bumper, that secure it to the frame. Once freed, detach the sides from the fender edges and complete the removal.


Updated on 17 February 2026 by ScegliAuto


Related tutorials

Instructions for Removing the Front Bumper
Instructions for Removing the Front Bumper
BMW Serie 3 (1990-2001 / E36) To comfortably remove the front bumper, position the vehicle on appropriate automotive jack stands and remove the front wheels, the plastic wheel wel…
Instructions for Removing Front Bumper
Instructions for Removing Front Bumper
BMW Serie 3 (2005-2013 / E92, E90, E91) Removing the front bumper does not require special recommendations, but it is important to locate all the mounting points to remove it correctly; ope…
Instructions for Removing the Rear Bumper
Instructions for Removing the Rear Bumper
BMW Serie 3 (1998-2006 / E46) Before starting the removal of the rear bumper, it is recommended to lift the vehicle on proper jack stands and remove the rear wheels, and also to o…

How to Reset the Tyre Light on a Toyota Aygo?

To reset the tyre light on a Toyota Aygo, start by locating the reset button, which is found in the glove compartment of the front passenger side. Turn on the car and ensure that the tyres are at the correct pressure. Then, press and hold the reset button for a few seconds until the tyre light either flashes or turns off, depending on the model. Release the button and wait for the reset procedure to complete. Restart your Toyota Aygo and check if the tyre light has turned off, indicating that the reset was successful.

Watch the video!


by ScegliAuto

More videos