Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the antenna of the BMW 3 Series.

Model: BMW Serie 3 E30 - Years 1982-1992
Part: Antenna

Below we will see the steps that will allow us to disassemble and replace the antenna of the BMW 3 Series. First, we open the rear door of the trunk and start removing the left side lining of the trunk, accessing the base of the antenna; we unscrew the fastening screws to remove the block, disconnect the electrical connector, and slide out the old antenna, as shown in the video. At this point, we carry out the repair or directly replace the antenna; we reassemble and connect the new antenna, following the video tutorial until the end!

Posted on 5 September 2023 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the antenna of the BMW 3 Series?
How do you replace the antenna of the BMW 3 Series?
BMW Serie 3 (2012-2019 / F31, F30) In order to replace the antenna of the BMW 3 Series, you need to pry it off with an object so that you can detach its cover, located at the rear of t…
How to replace the antenna grommet on a 1989 BMW E30
How to replace the antenna grommet on a 1989 BMW E30
BMW Serie 3 (1982-1992 / E30) In this video tutorial we can see how it is possible to replace the antenna rubber in a 1989 BMW E30 by following a few simple steps: the first thing…
How to change the car radio on BMW E46
How to change the car radio on BMW E46
BMW Serie 3 (1998-2006 / E46) Do we want to disassemble and replace the car radio from BMW? Let's see how the dashboard plastics can be removed from inside. Let's remove the moldi…

Installation of Upgraded Intercooler Radiator with Pipes

Lift the vehicle on suitable axle stands, remove the front wheels, and then the front bumper and grille. Proceed to remove the front headlights; drain the coolant, remove the intercooler radiator and the hoses connecting it to the intake system. Position the new intercooler radiator in the grille, temporarily securing it with cable ties, and mark with a marker the part of the metal that needs to be removed to allow the new hoses to pass through. Cut the marked portion of metal and apply a gasket to the edge. Remove the inner cover of the bumper and position it near the radiator to identify any interfering parts to eliminate: again, apply a gasket to the edge of the cut. Create brackets for securing the new radiator and proceed with the installation of the connecting pipes from the radiator to the intake, shaping and connecting them appropriately. Finally, reassemble the bumper, headlights, and grille.

Watch the video!


by ScegliAuto

More videos