Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Suspension Arm of Your Car

Model: BMW Serie 7 MK 3, E38 - Years 1994-2001
Part: Control arm

The suspension arm of your car connects the chassis to the struts. If it bends or wears out, it must be replaced as it could lead to loss of vehicle control. This is not a very complicated job to do on your own. This guide shows you how to do it. You will need to lift the car with a jack and then remove the wheel from the hub. Next, disconnect the stabilizer link from the arm without making any sudden movements. You will need two 14mm wrenches for this. Once the joint is removed, simply take out the bolts that hold the suspension arm in place to remove it.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Suspension Arm
Replacing the Front Suspension Arm
BMW Serie 7 (2001-2008 / E68, E65, MK 4, E67, E66) To replace the suspension arm, start by lifting the vehicle and removing the front wheel; then, unscrew the fastening nut of the ball joint attached …
Removal and Replacement of the Rear Control Arm on BMW 7 Series
Removal and Replacement of the Rear Control Arm on BMW 7 Series
BMW Serie 7 (1994-2001 / MK 3, E38) To remove and replace the rear control arm, proceed as follows: 1) Lift the vehicle off the ground using a jack or lifts. 2) Remove the rear wheel on…
How to adjust the suspension of the BMW 7 Series?
How to adjust the suspension of the BMW 7 Series?
BMW Serie 7 (2008-2015 / MK 5, F01, F02) The BMW 7 Series is equipped with suspension that can be adjusted so that the car's attitude can be lower or higher to suit your driving needs or roa…

How to Replace the Oil Sump on a Ford Focus

Follow these steps to remove and replace the oil sump on a Ford Focus engine. Lift the car on a column lift and (at your preferred height) use a socket wrench to unscrew the sump plug, allowing the oil to drain into a container (for disposal) and then re-screw the plug. Remove all the side plastics protecting the undercarriage using a battery or manual drill, then unscrew the fastening bolts around the perimeter of the oil sump. After removing the bolts from the sump, detach it from the engine block along with the gasket using a screwdriver as leverage. Clean everything and refit the new part.

Watch the video!


by ScegliAuto

More videos