Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Bumper on a BMW 4 Series

Model: BMW Serie 4 F32, F36, MK 1, F33 - Years 2013-2020
Part: Front bumper

Hello, in this video you will see how to remove the front bumper from the beautiful BMW 4 Series. It is quite a complex procedure. First, it is advisable to cover the front tires with durable plastic to avoid damaging the tire. Once that is done, you can start removing the bumper. Begin by opening the hood of your vehicle. Next, on the sides of the hood, there will be 4 bolts on each side; remove the bolts. Pull gently, being careful of the electrical connections. Take the new part, connect the relevant wires, and start installing your new bumper. Good luck!

Updated on 23 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to disassemble the rear bumper of the BMW 4 Series
How to disassemble the rear bumper of the BMW 4 Series
BMW Serie 4 (2013-2020 / F32, F36, MK 1, F33) The following steps will show us how to disassemble and replace the rear bumper of the BMW 4 Series, following the instructions below. First, let's m…
How to Replace the Front Parking Sensors on a BMW 4 Series
How to Replace the Front Parking Sensors on a BMW 4 Series
BMW Serie 4 (2020-2026 / G22, G23, G26, MK 2) This task seems easy but can be tricky because the bumper is full of sensors and delicate wiring: the new sensor must be the same part number, do not…
Where are the fuses located in the BMW 4 Series?
Where are the fuses located in the BMW 4 Series?
BMW Serie 4 (2013-2020 / F32, F36, MK 1, F33) The fuses of the BMW 4 Series are located inside the appropriate fuse boxes that are installed on the vehicle: in this type of vehicle it will be pos…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos