Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing Rear Light

Model: Chrysler Pt Cruiser MK 1 - Years 2000-2010
Part: Tail light

The rear light is secured with a single screw located at the bottom. To remove it, simply unscrew this single fixing screw and then take the light out of its housing. Once the light is removed, you can proceed to replace the bulbs or the entire light unit. For the installation of the new rear light, reverse the process by first positioning it at the top and then securing it with the single lower screw. Take care to tighten this screw without exceeding the torque to avoid damaging the plastic of the light.

Updated on 17 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Front Headlight Bulb
Replacing Front Headlight Bulb
Chrysler Pt Cruiser (2000-2010 / MK 1) To replace the front headlight bulb, it is necessary to remove the headlight itself, which also requires removing the front bumper: first, open the f…
Instructions for Removing the Rear Bumper
Instructions for Removing the Rear Bumper
Chrysler Pt Cruiser (2000-2010 / MK 1) To remove the rear bumper, first remove the plastic wheel arch liners from under the rear wheel arches (this operation is easier if the rear wheels a…
Front Headlamp Bulb Replacement and Headlamp Removal
Front Headlamp Bulb Replacement and Headlamp Removal
Chrysler Pt Cruiser (2000-2010 / MK 1) If possible, lift the vehicle on a hydraulic lift and remove the front wheel to facilitate disassembly. Along the wheel arch, you will see a cap tha…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos