Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Hydraulic Suspension Spheres

Model: Citroen Xantia MK 1 - Years 1993-2002
Part: Suspension system

The hydraulic spheres that control the vehicle's suspension system are located under the scuttle and in the engine bay. A special tool is required for disassembly, which can be easily made, along with a set of spanners. The spheres contain hydraulic fluid and are connected via a thin metal pipe that requires particular attention. Secure the tool around the sphere and tighten it firmly, then apply force to unscrew the sphere. Once loosened, continue unscrewing it manually. To collect the fluid inside before fully unscrewing it, wrap it in a plastic bag. Remove the old seal and clean the opening thoroughly before fitting the new one. Screw in and tighten the new sphere, and remember to top up the escaped hydraulic fluid.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the Suspension Wishbone Bush
Citroen Xantia (1993-2002 / MK 1) The failure of the support rubber (bush) of the front suspension wishbone is a fairly common defect and manifests as significant noise, especially wh…
Replacing the Cabin Air Filter
Replacing the Cabin Air Filter
Citroen Xantia (1993-2002 / MK 1) The cabin air filter is located on the passenger side, just below the glove compartment, above the scuff plate. To access the air duct, first remove …
Replacing the Car Cabin Air Filter
Replacing the Car Cabin Air Filter
Citroen Xantia (1993-2002 / MK 1) This guide explains how to replace the cabin air filter in your car. It is a procedure that should be done periodically and is essential for the heal…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos