Do it yourself
Frequently asked questions about cars and motorcycles

How to Change Engine Oil and Oil Filter on a Citroen C3 MK1

Model: Citroen C3 FC, FN - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Engine oil

See other generations:
Video tutorial

Let's see how to change the engine oil and filter on a Citroen C3 MK1: open the oil filler cap to assist with draining, remove the filter housing cover, and pull out the old filter element, placing a container underneath to catch the used oil that comes out with the filter.

Drain the old oil into a large basin, which you will then dispose of properly at an authorised centre.

Meanwhile, clean the filter cover, remove the old gasket, insert the new filter into the cover, and fit the new O-ring after lightly lubricating it with some new oil. Screw in a new drain plug and a new washer at the drain hole. Lower the car back to the ground, screw on the filter cover, and then refill with approximately 3.5 litres of new oil (as recommended by the manufacturer).

Close the cap, start the engine for a few minutes, turn off the engine, and wait 5 minutes. Check the level and top up until it reaches just below the Max level.


Posted on 16 February 2026 by ScegliAuto


Related tutorials

Citroen C3 (2016-2023 / SY, SX) In this video, we see a particularly practical method for replacing the oil filter of the Citroen C3 gasoline. We know that the oil filter loses part…
Citroen C3 (2009-2016 / SC) The video shows how to change the engine oil in a Citroen C3. Follow the steps to perform this DIY maintenance independently. First, gather all neces…
Citroen C3 (2009-2016 / SC) Learn how to service your Citroen C3, including the oil change. Follow these steps. Lift the car using a jack and unscrew the bolt from the oil sump …

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos