|
Do it yourself
| |||
| ||||
How to Change the Engine Oil and Oil Filter on a Citroen Xsara Picasso
Model: Citroen Xsara Picasso
MK 1
- Years 1999-2012
Let's see how to change the oil and filter on a Citroen Xsara Picasso: slightly warm the oil, then lift the car using two axle stands. Open the bonnet and unscrew the oil cap to facilitate draining, then position a large container under the oil drain plug located under the vehicle and unscrew it, being careful during the last turns when the used oil will all come out at once. While the oil drains, unscrew the filter counterclockwise: you will also need a container here, as the filter is also full of oil. The used oil and filter must be disposed of properly at an authorised centre. Clean the seating area well, remove the gasket if it remains in place, take the new filter, lubricate the gasket with clean oil, and replace the filter. Fit a new gasket and cap to the sump, then lower the vehicle. Now, refill the oil from the top using a funnel: pour about 90% of the quantity indicated in the owner's manual. Close the cap and start the engine for 30 to 60 seconds to fill the filter, wait a couple of minutes, and then check the level with the dipstick, topping up again until reaching the "max" level, which must NEVER be exceeded.
Posted on 4 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Citroen Xsara Picasso
(1999-2012 /
MK 1)
Let's see how to change the engine oil, and of course the corresponding filter, in a 2006 Xsara Picasso. To facilitate the draining process, open the…
Citroen Xsara Picasso
(1999-2012 /
MK 1)
Today we will explain how to replace the oil filter and engine oil on a Citroen Xsara Picasso vehicle by yourself. To perform the oil change, we reco…
Citroen Xsara Picasso
(1999-2012 /
MK 1)
Today we will see how to replace the engine oil filter and the engine oil on a Citroen Xsara Picasso. We pull the hood release lever to access the en…
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.429
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |