Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C3
    4. : How to open the bonnet of the Citroen C3?

Citroen C3 - Video tutorial

Model: Citroen C3 SX, SY - Years 2016-2023
Part: Bodywork
Operation: How to open the bonnet of the Citroen C3?

To unlock and open the front bonnet of the Citroen C3 it is necessary to proceed as follows: open the door on the driver's side and access the driver's seat, at the bottom left under the dashboard at floor level and near the door there is the lever to release and open the bonnet. Pull it completely towards you, get out of the passenger compartment and position yourself in front of the bonnet, insert your hand into the gap created between the bonnet and the grille and release the tab. At this point it will be possible to raise the engine hood. Finally, fix the support rod on the hole on the top of the bonnet.


Posted on 25 October 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • C3 2009-2016 - How much does it cost to replace the airbumps on a Citroen C3? Read Answer
    • C3 2009-2016 - How much does it cost to replace the sunroof of the Citroen C3? Read Answer
    • C3 2009-2016 - Where are the Citroen C3's airbag impact sensors located? Read Answer
    • C3 2016-2023 - How much does it cost to repair the Citroen C3 Pluriel soft top? Read Answer
    • C3 2002-2009 - Where does the front hood of the Citroen C3 open from? Read Answer
    • C3 2009-2016 - How to open the hood on Citroen C3? Read Answer
    • C3 2002-2009 - Where is the color code Citroen C3 pluriel? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos