Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Dacia
    3. :
  3. Sandero
    4. : How to replace the rear light bulb in a Dacia Sandero 1.

Dacia Sandero - Video tutorial

Model: Dacia Sandero BS - Years 2008-2012
Part: Tail light
Operation: How to replace the rear light bulb in a Dacia Sandero 1.

In this video tutorial we can see how it is possible to replace the rear light bulb in a Dacia Sandero 1, following some simple steps: the first thing to do is to buy the H4 12V bulbs, at an authorized dealer (See video) . To make the bulbs last longer, it is recommended that you never touch the glass with your fingers. Get in the car, turn off the car and apply the handbrake. Open the rear trunk and remove the plastic wing nut securing the headlight. Now pull the headlight horizontally to remove it from its seat, remove the power connector by pushing on the small plastic tab; remove the support plate by moving the tabs away from the support. To remove the bulbs you have to push and rotate them a quarter of a turn; at this point it will be possible to insert the new bulbs and reassemble them by proceeding backwards.


Posted on 23 September 2022 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos