Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil in a Datsun Go

Model: Datsun Go MK 1 - Years 2013-2022
Part: Engine oil

Below, discover how to correctly change the engine oil and the related filter in the Datsun Go. Before starting, remember that the entire procedure must be performed with the engine off and cold. Lift the car with a hydraulic jack and access the lower area of the engine compartment. Locate the oil pan and place a sufficiently large container directly underneath. Unscrew the oil pan plug and let all the used oil drain out. Next, reattach the plug and proceed with replacing the filter. At this point, move to the top of the engine compartment and fill the pan with new oil.

Updated on 16 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Engine Oil and Oil Filter of the Datsun Go
How to Replace the Engine Oil and Oil Filter of the Datsun Go
Datsun Go (2013-2022 / MK 1) Let's look at the procedure necessary for replacing the engine oil and oil filter while performing the routine maintenance service on the Datsun Go. …
Change the Engine Oil and Oil Filter on a Datsun Go
Change the Engine Oil and Oil Filter on a Datsun Go
Datsun Go (2013-2022 / MK 1) This short and simple video will show you the steps to perform the routine maintenance service by changing the engine oil and oil filter on the Datsu…
How to Change the Transmission Fluid in a Datsun Go
How to Change the Transmission Fluid in a Datsun Go
Datsun Go (2013-2022 / MK 1) In this video tutorial, you will learn how to change the transmission fluid in a Datsun Go, following the instructions below. First, lift the vehicle…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos