|
Do it yourself
| |||
| ||||
How to perform a full service on a Fiat Punto 1.2 petrol
Model: Fiat Punto
199, MK 3, Grandepunto , Punto EVO
- Years:
2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Video tutorial
In this video, we see how to perform a full service on a Fiat Punto 1.2 petrol: first, open the oil filler cap, then open the drain plug located under the vehicle, placing a container to collect the used oil, which will then be disposed of at an authorised centre; using a special cup for removing the filter (if possible), remove the filter, which is located right next to the sump; take care as this will also leak oil, try to direct it into the same container. Meanwhile, change the air filter inside the engine bay by first disconnecting the inlet pipe, then unscrewing the two securing pins and lifting the entire airbox, removing the smaller pipes. Unscrew the three screws on top and the three screws underneath, and change the filter inside, then refit the airbox. Replace the oil cap on the sump (preferably new), then top up with new oil using a funnel, and change the oil filter. Inside the passenger footwell, you will find the pollen filter, where the cover is held by a tiny screw; change the filter after cleaning the compartment of dirt and debris, and close the cover. Now start the vehicle for a minute and check the oil level.
Updated on 4 November 2026 by ScegliAuto
Related tutorials
Fiat Punto
(2005-2018 /
199, MK 3, Grandepunto , Punto EVO)
Follow the steps in the video to remove the fuel pump assembly on the Fiat Punto. Lift the rear seat and unscrew and remove the cover in front of you…
Fiat Punto
(1999-2011 /
MK 2, 188)
In this video tutorial, you will learn how to replace the fuel pump on a Fiat Punto mk2 as well as other models from the Fiat group. First, remove th…
Fiat Punto
(1999-2011 /
MK 2, 188)
The fuel pump on the second series Fiat Punto is located under the rear seat bench. Start by removing the rear seat bench by unhooking it. This will …
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Reset the Tire Pressure Light on a MG ZS?
On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.056
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |