Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to disassemble and replace the water pump on a Fiat 500

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2023
Part: Pump
Operation: How to disassemble and replace the water pump on a Fiat 500

Let's see in this video how to disassemble and replace the water pump on a Fiat 500. Lift the engine hood and put it in safety, then, with a screwdriver, unscrew the locking pins of the ventilation pipe, remove the soundproofing panel from the engine compartment . We begin to disassemble the tightening pins of the water pump with a socket wrench as in the video. Once the piece has been disassembled from its seat, disconnect the power supply terminals and remove it. Finally we reassemble the water pump in the engine compartment, after having cleaned it from any traces of dirt and encrustations, the aeration tube can be mounted with the soundproofing panel.


Posted on 13 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2007-2022 - Where is the water pump located on the Fiat 500? Read Answer
    • 500 2007-2023 - How does the fuel pump work on Fiat 500? Read Answer
    • 500 2012-2023 - What does the Fiat 500 L injection pump warning light indicate? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos