Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change oil and filter on a Fiat Doblò 1

Model: Fiat Doblo 223, MK 1, Doblo 1 - Years 2000-2009
Part: Engine oil

In this video, we see how to change the oil filter on a Fiat Doblo 1: first, we need to open the oil filler cap and lift the car, then get a basin to collect the oil that will inevitably drip from the sump and filter when we remove them; we will then dispose of the used oil at an authorized center. While the oil drains, we change the filter and gasket, which we will lubricate with some clean oil before placing it. We put the filter back in place, put a new cap and a new gasket on the sump. Now we refill the oil following the instructions in the owner's manual, both for the quantity and the type of oil. We fill it up to 90% of the capacity and then measure it; we will then add more until it reaches just below the "max" level on the dipstick. Now we put the cap back on and run the engine for a few minutes at idle, after which we measure the oil level again.

Posted on 24 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Air Filter on a Fiat Doblo
How to Replace the Air Filter on a Fiat Doblo
Fiat Doblo (2000-2009 / 223, MK 1, Doblo 1) Before you start, open the bonnet of your Fiat Doblo. Begin by unscrewing and removing the screws that secure the air filter cover. Next, unclip and …
How to change oil and filter on a Fiat Doblò MK1
How to change oil and filter on a Fiat Doblò MK1
Fiat Doblo (2000-2009 / 223, MK 1, Doblo 1) Let's see how to replace engine oil and oil filter on a Fiat Doblò MK1: slightly warm up the engine, lift the vehicle, place a large basin under the …
How to Reset the Oil Warning Light on a Fiat Doblò?
How to Reset the Oil Warning Light on a Fiat Doblò?
Fiat Doblo (2022-2026 / Doblo -3) To reset the oil warning light on a Fiat Doblò, you need to change the oil by draining the old oil from the drain plug at the bottom of the engine co…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos