|
Do it yourself
| |||
| ||||
Video tutorial
In this video, we will see how to start a car with a flat battery using jumper cables. In the video, we see a Fiat 500, but the method is almost the same for all cars. Of course, you will need another car with a fully charged battery on hand. We will need to park the two cars with their hoods close together and turned off: open the hoods of both cars and locate the batteries; not all cars have the battery in the engine compartment, but manufacturers have included accessible alternative terminals for this purpose. Take the red cable and connect it to the positive terminal of the battery, then connect the other end of the red cable to the positive terminal of the flat battery. Continue by connecting the black cable clamp to the negative terminal of the charged battery and then to the flat battery. Start the engine of the car with the charged battery, keeping the engine at 2000/2500 rpm, then start the engine of the car with the flat battery. Once it starts, leave it running and disconnect the cables, following the exact reverse order: then drive the car for at least 15 minutes so that the battery can recharge.
Posted on 8 May 2025 by ScegliAuto
Related tutorials
Fiat 500
(2007-2022 /
)
In this short video, you will see how to easily wind the key spring on the remote of a Fiat 500 if the key no longer comes out of its housing. It is …
Fiat 500
(2007-2024 /
312)
Let's see how to change the battery of a Fiat 500, which has a complex control unit, so disconnecting the battery will reset all parameters; it is ad…
Fiat 500
(2007-2021 /
312)
In this video tutorial, you can see how to install the GPS "OCTO TELEMATICS" by following a few simple steps that will guide you towards proper vehic…
Other guides you may be interested in
|
How to Remove the Toll Tag Holder from the Car Windscreen
The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.050
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
