Do it yourself
Frequently asked questions about cars and motorcycles

Removing EGR Valve from Fiat 1.3 MultiJet and Opel Corsa

Model: Fiat Punto MK 3, Punto EVO, 199, Grandepunto - Years 2005-2018
Part: EGR valve

In this video, you will see how to remove the EGR valve from Opel engines (including the Corsa, 1.3 MultiJet) and Fiat diesel engines (1.3 MultiJet). First, make some space by removing the air filter along with the entire airbox: also disconnect the intake duct by unscrewing the relevant clamp. After removing the first part of the duct, completely remove the intake manifold: disconnect the connector located next to it. Now, remove the two water pipes located further forward and unscrew the relevant clamps. At this point, you will have access to the EGR valve: take care with the gaskets.

Updated on 18 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Punto (1999-2011 / MK 2, 188) When your car suddenly starts to jerk and lose power, it may be due to a clogged EGR valve, which requires a cleaning treatment. The video shows exac…
Fiat Punto (1999-2011 / MK 2, 188) In this short and simple guide, you will see the steps to remove and clean the EGR valve on the Fiat Punto 1.9 JTD. First, open the bonnet of your ca…
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) In this video, you will see how to remove the EGR valve from a Grande Punto diesel. The EGR valve is a very delicate component in cars as it helps li…

Other guides you may be interested in

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the EGR valve located on a Fiat Punto 1.3 multijet? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos