Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Cabin Fan of a Fiat Scudo

Model: Fiat Scudo MK 2 - Years 2007-2016
Part: Blower motor

Today, you will learn how to remove the cabin fan of a second-generation Fiat Scudo by following the main instructions below. First, get inside the vehicle and start by removing the side plastic panels of the glove compartment; open the glove compartment and unscrew all the fastening screws to access the cabin fan. At this point, locate the fan and disconnect its power electrical connector; all that's left is to unscrew the two fastening screws to remove it, so you can replace it with a new one!

Updated on 1 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Guide to Replace the Cabin Fan Resistor on the Fiat Scudo (2005)
Guide to Replace the Cabin Fan Resistor on the Fiat Scudo (2005)
Fiat Scudo (1996-2007 / MK 1) In today's video tutorial, you will see how to remove and replace the air conditioning and cabin fan resistor on the 2005 Fiat Scudo, following the i…
How to replace the cabin air filter of the Fiat Scudo
How to replace the cabin air filter of the Fiat Scudo
Fiat Scudo (2007-2016 / MK 2) If you want to independently replace the air filter located in the cabin of your Fiat Scudo, you just need to read the following guide and put into p…
Replacing the Headlight Bulb of the Fiat Scudo
Replacing the Headlight Bulb of the Fiat Scudo
Fiat Scudo (2007-2016 / MK 2) This guide briefly outlines the main instructions for removing and replacing the headlight bulb of the Fiat Scudo. First, open the bonnet of your car…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos