Do it yourself
| ||||
|
Fiat Multipla - Video tutorial
Model: Fiat Multipla
MK 1
- Years 1998-2010 Let's see in this video how to change the engine oil and the oil filter, also performing the routine maintenance coupon, on a Fiat Multipla second series, with MultiJet engine. First of all we lift the car and go to unscrew the oil vent bolt; then we drain all the oil in a container for at least twenty minutes. At this point we proceed with the replacement of the oil filter; unscrew it with the appropriate key and replace it with the new one, remembering to screw it in and tighten it by hand. We just have to insert the new engine oil, following the video until the end for the complete service!
Posted on 18 January 2024 by ScegliAuto
Other guides that may interest you
|
Replace the steering angle sensor on the Volkswagen Golf 5When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.075
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |