Do it yourself
| ||||
|
Fiat Punto - Video tutorial
Model: Fiat Punto
188, MK 2
- Years 1999-2011 Open the bonnet and use a screwdriver to pry the upper hole of the front panel to release it, subsequently removing the other fasteners as well. Unscrew the seven screws from the lower bezel with a Torx wrench. Squeeze the plastic catches and remove the air intake grilles. In the hole in the air intakes, unscrew the sealing screw and the four side screws inside the two mudguards. At this point the bumper is free, so carefully remove it from the front of the car by disconnecting the two side cables. The lighting assembly is now ready for replacement. Unscrew the lower and upper sealing screws and remove it by disconnecting the connector of the electrical wiring. By placing the bulbs in the holder and reconnecting the connector, install the new headlights. Test by turning on the headlights to verify correct operation. Refit the bumper and grille.
Posted on 16 July 2023 by ScegliAuto
Removing the front headlight on Fiat Punto
Fiat Punto (1999-2011 / 188, MK 2) Let's see how we remove the headlight of a Fiat Punto. We open the bonnet and put it in safety with the dipstick; remove the front bumper (screws pla
How to replace the front headlight of the Fiat Punto.
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) Removing the front headlight of the Fiat Punto is a very simple operation to perform independently. The first thing to do is to open the front hood a
How do you replace the front turn signal bulb of the Fiat Punto?
Fiat Punto (1999-2011 / 188, MK 2) In order to replace the front indicator bulb of the Fiat Punto bis, you need to open the hood so that you can loosen the screws that secure the corre Other guides that may interest you
|
Frequently Asked QuestionsFiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.048
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |