Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Front Hub Support Revision

Model: Fiat Panda 141, MK 1 - Years 1980-2003
Part: Axle shaft

The hub support plate integrates a spherical joint that tends to wear and develop play over time: it is possible to purchase a new support plate complete with joint in the aftermarket, but to replace it, it is necessary to remove the bracket and hub completely from the vehicle. Once the bracket with the hub is on the bench, unscrew the four fixing pins of the bracket to the hub and, proceeding in reverse, install the new bracket complete with joint. It is recommended to perform the same maintenance on the other wheel to provide symmetrical stiffness to the front end.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Front Hub Bearing
Replacement of Front Hub Bearing
Fiat Panda (1980-2003 / 141, MK 1) Lift the vehicle on suitable axle stands and remove the wheel on which the repair will be carried out; continue by removing the brake caliper, the di…
Instructions for Removing the Half Shaft
Instructions for Removing the Half Shaft
Fiat Panda (1980-2003 / 141, MK 1) To remove the half shaft, first assess how to loosen the fastening nut on the hub side: instead of using the method shown in the video, which involve…
Gearbox Revision on Fiat Panda 4x4
Gearbox Revision on Fiat Panda 4x4
Fiat Panda (1980-2003 / 141, MK 1) This tutorial for experienced mechanics begins with the gearbox already removed from the car. Using a 30 mm socket, unscrew the upper nuts: if they a…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos