Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Front Wing on a Fiat Punto?

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Checks and maintenance

To replace the front wing on a Fiat Punto, open the bonnet to access the engine bay and loosen the screws located on the side of the engine bay. Once these are loosened, open the door and loosen the screws near it, both at the top and bottom. At this point, you can detach the rivets found inside the wheel arch to remove the side of the front bumper. The wing can then be removed and replaced with a new spare part.

Updated on 1 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Punto (1999-2011 / MK 2, 188) In this video, see the main instructions on how to remove and replace the front wing on a Fiat Grande Punto, following the steps outlined below. Firs…
Fiat Punto (1999-2011 / MK 2, 188) To start this operation, you need to release the bonnet from the lever to lift it and secure it with the appropriate rod. Then, remove the bolts indi…
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) This operation takes just a few minutes. Simply release the bonnet to lift it and secure it with the prop rod. Pay attention to ensure the connector …

Other guides you may be interested in

    Frequently Asked Questions

    • Punto 2005-2018 - What problem does the Fiat Punto have with the "city mode"? Read answer
    • Punto 2005-2018 - How to bleed the Fiat Punto clutch pedal? Read answer
    • Punto 2005-2018 - What does the words "ESP, Hill holder not available" mean on the Fiat Punto Evo? Read answer
    • Punto 1999-2011 - How do you remove the headrest of the Fiat Punto 1.2? Read answer
    • Punto 2005-2018 - Where is the inertia switch on the Fiat Punto? Read answer
    • Punto 2005-2018 - How do i remove the center console of my Fiat Punto? Read answer
    • Punto 1999-2011 - How does the air conditioning of the Fiat Punto work? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos