Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Injection ECU from a Fiat Panda

Model: Fiat Panda 169, MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Control unit

See other generations:
Video tutorial

For safety reasons, remove the ignition key, pull the handbrake, and disconnect the battery. Remove the air intake hose by pressing the levers and pulling.

Disconnect the electrical part by pulling the tab on the two connectors and sliding them out. Now, using a 10mm socket, unscrew the three bolts (one is for the ground signal). Voila! At this point, you will have the injection ECU in your hand.

You may notice that the ECU does not have screw holes, so a rear bracket has been added for its fastening. Fit the new ECU and proceed in reverse order.


Updated on 2 May 2026 by ScegliAuto


Related tutorials

How to Remove the Horn from a Fiat Panda
How to Remove the Horn from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before you can begin, open the front bonnet of your Fiat Panda. Start by unscrewing and removing the screws that secure the front mask, then remove t…
How to Replace the Gear Knob on a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) Before you can start, sit in the driver's seat of your Fiat Panda. It is strongly advised to perform this operation with the engine off, to avoid acc…
How to Remove the Horn from a Fiat Panda
How to Remove the Horn from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before starting, open the front bonnet of your Fiat Panda. Begin by unscrewing and removing the screws that secure the grille at the front of the car…

    Frequently Asked Questions

    • Panda 2012-2026 - Start and stop not available on Fiat Panda: what to do? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos