Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to remove the front headlights of the Fiat 500 Abarth

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2021
Part: Headlight
Operation: How to remove the front headlights of the Fiat 500 Abarth

Let's find out in this guide how to remove and replace the front lights of the Fiat 500 Abarth. First of all we open the bonnet and start by removing the screws that we find both on the upper part and on the lower part of the front bumper; we also remove the screws that we find on both sides of the front wheel arches, as shown in the video. At this point, once the bumper has been removed, we can unscrew the screws of the front light; we disconnect the electrical connector of the bulb to remove the optical group and replace it with the new one, following the video to the end!


Posted on 8 April 2024 by ScegliAuto

    Frequently Asked Questions

    • 500 2012-2023 - What can be the reason why the daytime running lights on the Fiat 500 do not light up? Read Answer
    • 500 2007-2022 - Why don't the daytime running lights on the Fiat 500 work? Read Answer
    • 500 2007-2022 - What model are the front position light bulbs of the Fiat 500 series 312? Read Answer
    • 500 2007-2023 - How to remove the headlights on Fiat 500? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos