Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Glove Compartment from the Fiat Panda

Model: Fiat Panda 169, MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Glove compartment

See other generations:
Video tutorial

In today's video tutorial, learn how to remove the glove compartment and install the bulb in the Fiat Panda by following the instructions below. First, get in the vehicle and open the glove compartment; to remove it, unscrew the screws located at the top, then disconnect the electrical connector of the bulb, as shown in the video.

At this point, completely remove the glove compartment; then install the new bulb and reassemble everything, following the video to the end!


Updated on 12 May 2026 by ScegliAuto


Related tutorials

How to Remove the Glove Compartment from the Centre Tunnel of a Fiat Panda
How to Remove the Glove Compartment from the Centre Tunnel of a Fiat Panda
Fiat Panda (1980-2003 / MK 1, 141) Learn how to remove the glove compartment from the centre tunnel of a Fiat Panda. Using a plastic lever, pry off the cover located at the bottom of t…
How to Remove the Horn from a Fiat Panda
How to Remove the Horn from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before you can begin, open the front bonnet of your Fiat Panda. Start by unscrewing and removing the screws that secure the front mask, then remove t…
How to Replace the Gear Knob on a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) Before you can start, sit in the driver's seat of your Fiat Panda. It is strongly advised to perform this operation with the engine off, to avoid acc…

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos