Do it yourself
| ||||
|
Fiat Panda - Video tutorial
Model: Fiat Panda
169, MK 2
- Years 2003-2012 The video shows us how to proceed with the coupon and therefore also the change of the oil and the relative filter in a 2016 Fiat Panda 4x4 1.6 multijet. First of all, we open the bonnet and fix it using the special safety catch . After that we will have to lift the car and remove the cover under the engine in order to have access to the oil drain plug. The cover can be removed using a 10mm wrench to unscrew the eight bolts present; At this point we will be able to identify the oil sump, from which we will unscrew the cap with the appropriate key; remember to use a container in which to let the used oil drain. To make the oil drain better it will be useful to open the upper oil cap, the breather will facilitate emptying the sump. At this point we will go to work inside the hood and we will have to locate the filter, which will be located under a duct that we will have to disassemble with special screwdrivers and a 7mm bolt wrench. Now with a key no. 27 we will unscrew the filter and then extract it. Once the old filter has been extracted, we will have to remove the gasket present from the filter container and replace it with a new one, then we can insert the new filter. Before reassembling it we will have to wet the gasket with oil, in this way it will be possible to put it back in its seat and proceed to screw all the previously disassembled components back on.
Posted on 24 April 2023 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.054
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |