Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Oil and Oil Filter on the Fiat Panda 169 4x4

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Oil filter

Let’s discover the procedure to perform routine maintenance by replacing the engine oil and oil filter on the Fiat Panda 169 4x4. First, lift the vehicle and start by removing the oil drain bolt located under the engine; then unscrew the oil filter using the appropriate tool. At this point, screw and hand-tighten the new filter, and then pour in the new engine oil; it is important to use a good quality oil, especially with the correct grade (in this case, 10w40).

Updated on 26 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Rear Differential Oil of the Fiat Panda 4x4 169
How to Change the Rear Differential Oil of the Fiat Panda 4x4 169
Fiat Panda (2003-2012 / 169, MK 2) In today's tutorial video, we will see how to change the rear differential oil on the Fiat Panda 4x4 169. Start by lifting the car and locating the p…
Oil Filter Replacement for Fiat Panda 4x4 1.2 Petrol
Oil Filter Replacement for Fiat Panda 4x4 1.2 Petrol
Fiat Panda (2003-2012 / 169, MK 2) Whenever you change the engine oil, it is advisable to replace the oil filter as well; for this engine, the oil filter is the classic metal filter sc…
How to Replace the Drive Shaft on a Fiat Panda 169 4x4
How to Replace the Drive Shaft on a Fiat Panda 169 4x4
Fiat Panda (2003-2012 / 169, MK 2) Discover in this video the instructions for replacing the drive shaft on a Fiat Panda 169 4x4. First, lift the vehicle and position the jack under th…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos