Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Fiat
  4. :
  5. 500
  6. : How to disassemble the starter motor of a vintage Fiat 500

Fiat 500 - Video tutorial

Model: Fiat 500 Epoca - Years 1957-1975
Part: Starter motor
Operation: How to disassemble the starter motor of a vintage Fiat 500

In today's video we see how to proceed with the disassembly and overhaul of the starter motor of the vintage Fiat 500. This tutorial also applies to the later Fiat 126, also equipped with a rear engine. First of all, remember to intervene only and exclusively with a cold engine to avoid possible problems. At this point we proceed by opening the rear engine hood, then identify the unit in question. We proceed to its extraction and take us to the work table. So let's disassemble our alternator and proceed to rectify the component and then test it.


Posted on 5 May 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2007-2022 - What problems does the Fiat 500 starter have? Read Answer
    • 500 2012-2023 - How to solve the problem of the start & stop not working on the Fiat 500L? Read Answer
    • 500 2007-2021 - How much does it cost to replace the ignition lock of the Fiat 500? Read Answer

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos