Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing and Replacing the Starter Motor on the Fiat 500

Model: Fiat 500 312 - Years 2007-2022
Part: Starter motor

In this short and simple guide, learn how to remove and replace the starter motor on the Fiat 500 by following the instructions below. First, open the bonnet of the vehicle and start unscrewing the fixing screw located at the top of the starter motor, using a socket spanner; then raise the vehicle to unscrew the additional screws located at the bottom of the starter motor, as illustrated in the video. At this point, disconnect the electrical wiring to remove and replace the starter motor with a new one!

Updated on 24 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Disassembly and replacement of the starter motor of the Fiat 500 1.2
Disassembly and replacement of the starter motor of the Fiat 500 1.2
Fiat 500 (2007-2024 / 312) The following steps will show us how to disassemble and replace the starter motor of the Fiat 500 1.2. First of all, we open the hood of the car and …
Disassembly of the Fiat 500 starter motor
Disassembly of the Fiat 500 starter motor
Fiat 500 (2007-2024 / 312) Today's main steps will show us how to disassemble and replace the starter motor of the Fiat 500, following the instructions below. First, we open th…
How to Time the Engine of the Classic Fiat 500
Fiat 500 (1957-1975 / Epoca) This guide will show you the information needed to time the engine of the classic Fiat 500. First, open the rear bonnet and locate the distributor, w…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos