Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Replacing the Clutch on a Fiat 500 1.2

Model: Fiat 500 312 - Years 2007-2022
Part: Clutch

In this video tutorial, you will see the main instructions for removing and replacing the clutch on the Fiat 500 in simple and quick steps. First, open the bonnet of your car and start by removing the front bumper, then take out the battery and battery tray; next, disconnect all the various wiring, including the voltage regulator, as shown in the video. At this point, lift the vehicle and remove the driveshaft, then take off the gearbox; separate the transmission and replace the clutch, following the video tutorial to the end!

Updated on 17 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Clutch on a Fiat 500 1.2
Replacing the Clutch on a Fiat 500 1.2
Fiat 500 (2007-2021 / 312) Today, you will learn the main steps to remove and replace the clutch assembly on a Fiat 500. First, lift the vehicle and remove the front wheels; th…
How do you make a double on a vintage Fiat 500?
How do you make a double on a vintage Fiat 500?
Fiat 500 (1957-1975 / Epoca) On Fiat 500 cars made before 1975, the gearbox was not synchronized, so to change gears we had to perform what is called a "double-clutching" but in …
How to Replace the Clutch Pedal Switch on a Fiat 500?
How to Replace the Clutch Pedal Switch on a Fiat 500?
Fiat 500 (2007-2021 / 312) To replace the clutch switch on a Fiat 500, access the rear of the clutch pedal. This switch lifts upwards when the clutch pedal is pressed, allowing…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos