Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Multipla
    4. : Cabin air filter replacement

Fiat Multipla - Video tutorial

Model: Fiat Multipla MK 1 - Years 1998-2010
Part: Cabin air filter
Operation: Cabin air filter replacement

The passenger compartment air filter is located immediately under the windscreen, on the passenger side: therefore remove the plastic protective grille to access the filter housing; then remove the cap of the filter container and extract the latter from its seat, eliminate any residual dirt inside and apply the new filter (we recommend the activated carbon filter) orienting it respecting the direction of the air flow, indicated by the arrows on the filter itself; complete the installation by replacing the cap and grille. When replacing the filter, it is advisable to also sanitize the passenger compartment with a germicidal spray.


Posted on 26 August 2023 by ScegliAuto



Cabin air filter replacement
Fiat Multipla (1998-2010 / MK 1) The passenger compartment air filter is located under the plastic cover positioned just below the windscreen, on the passenger side, right in corresp
Replacing the cabin pollen filter on a Fiat Multipla
Fiat Multipla (1998-2010 / MK 1) How to replace the cabin pollen filter on the Fiat Multipla? Let's see in this video how to do the disassembly. We remove with a lever, the plastic p
How to replace the passenger compartment air filter on a Fiat Multipla
Fiat Multipla (1998-2010 / MK 1) Before we can start, we will have to get out of the cockpit of our Fiat Multipla, and then raise the front windshield wipers. So let's start by disen

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos