Do it yourself
| ||||
|
Fiat Panda - Video tutorial
Model: Fiat Panda
169, MK 2
- Years 2003-2012 Changing the clutch cable on a Fiat Panda is not a difficult operation. First, you will need to remove the battery and air filter assembly as shown in the video. You must then remove the broken black cable, being careful to set aside the rubber grommet and the two 10 millimeter nuts that support it. From inside the Panda, you must pass the cable through the pedal hole and hook it onto the hook side, securing it with the previously set aside grommet. Pass the cable through the fixed relay hole and then through the mobile lever hole, finally screwing in the two nuts that were previously set aside.
Posted on 31 May 2023 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the TPMS light of the Volkswagen Polo 2011The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.072
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |