|
Do it yourself
| |||
| ||||
How to Remove the Indicator Stalk on Fiat Punto Evo
Model: Fiat Punto
MK 3, Punto EVO, 199, Grandepunto
- Years 2005-2018
The failure of the indicator stalk, particularly the flat cable inside, is a common fault on this car model, resulting in the airbag warning light illuminating and the controls on the steering wheel not functioning; replacing this part is relatively simple, and it is strongly recommended to replace the part rather than attempting a repair; to begin, disconnect the battery, then release the airbag by pressing the relevant retaining clips through the holes behind the steering wheel spokes; continue by removing the covering panels of the indicator stalk and the steering wheel retaining bolt to free the indicator stalk; at this point, disconnect the connectors and loosen the collar clamp bolt that secures the indicator stalk to the steering column and remove it from its housing.
Updated on 18 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Fiat Punto
(2005-2018 /
MK 3, Punto EVO, 199, Grandepunto )
These short and simple instructions will show us the process of disassembling and replacing the stop light switch of the Fiat Grande Punto, as well a…
Fiat Punto
(2005-2018 /
MK 3, Punto EVO, 199, Grandepunto )
Let's briefly see the main instructions that will allow us to disassemble and replace the external lights switch or control of the Fiat Grande Punto,…
Fiat Punto
(2005-2018 /
MK 3, Punto EVO, 199, Grandepunto )
In order to replace the turn signal switch of the Fiat Punto, you will need to remove the airbag located in the center of the steering wheel from its…
Other guides you may be interested in
|
Frequently Asked QuestionsWhere is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.111
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |