Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Coolant in the Fiat Panda 0.9 TwinAir

Model: Fiat Panda 319, MK 3 - Years 2012-2026
Part: Antifreeze coolant

This guide outlines the steps to bleed and top up the engine coolant in the Fiat Panda 0.9 TwinAir. First, open the bonnet and begin unscrewing the cap of the coolant reservoir; then raise the vehicle and disconnect the radiator hose by loosening the metal clip, allowing the fluid to drain into a container. At this point, top up with the new coolant by pouring it into the designated reservoir until it reaches the maximum level mark!

Updated on 16 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Panda (1980-2003 / 141, MK 1) To replace the coolant in the Fiat Panda, access the underside of the car and loosen the retaining ring that secures the cooling hose to the tank. By…
Fiat Panda (2012-2026 / 319, MK 3) To top up the coolant of the Fiat Panda, you will need to open the hood so that you can locate the components inside the engine compartment: in the t…
Fiat Panda (2003-2012 / 169, MK 2) Is the radiator fluid due for replacement? Let’s look at draining the coolant on a Panda. Lift the car on a jack, disconnect the radiator hose at the…

Other guides you may be interested in

    Frequently Asked Questions

    • Panda 2012-2026 - Where to put water in the Fiat Panda? Read answer
    • Panda 2003-2012 - Where are the water bleed valves of the Fiat Panda? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos