Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove and Replace the ECU of the Fiat Panda

Model: Fiat Panda 319, MK 3 - Years 2012-2026
Part: Control unit

This guide illustrates the main steps to remove and replace the ECU of the Fiat Panda, following the instructions below. First, open the bonnet of the vehicle and disconnect the battery; locate the ECU next to it, as shown in the video. Next, unscrew its fixing screws and disconnect the various electrical connectors to remove it from the engine bay for repair or replacement; then connect the new ECU and reassemble everything, applying the reverse procedure!

Updated on 23 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the ECU in the Fiat Panda?
Where is the ECU in the Fiat Panda?
Fiat Panda (2012-2026 / 319, MK 3) This video shows where the engine control unit (ECU) is located in the Fiat Panda, useful if you need to replace it. As shown, it is situated inside …
Multiecuscan Software to Reset the Service Light on the Fiat Panda 1.2 8V
Fiat Panda (2012-2026 / 319, MK 3) If the Service light comes on in your Fiat Panda, it means that the service is overdue, so you can either consult your trusted mechanic or wait for i…
Removing the Injection ECU from a Fiat Panda
Removing the Injection ECU from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) For safety reasons, remove the ignition key, pull the handbrake, and disconnect the battery. Remove the air intake hose by pressing the levers and pu…

Other guides you may be interested in

    Frequently Asked Questions

    • Panda 2012-2026 - Start and stop not available on Fiat Panda: what to do? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos