How to Replace the Shock Absorbers on a Fiat Bravo

Today, follow these steps to replace the shock absorbers on a Fiat Bravo model 2. The first step is to: - open the bonnet; - clean the fastening elements of the upper support of the shock absorber strut using a wire brush and WD-40 spray. The second step is to: - remove the rubber adhesive seal and loosen the upper fastening elements of the shock absorber support with a 19 mm spanner.

The third step is to: - remove the front wheel and disconnect the wiring and brake hose from the shock absorber support bracket using a crowbar. - unscrew the nut and remove the stabiliser bar from the shock absorber support with a 17 mm spanner and a ratchet.

The fourth step is to: - unscrew the fastening elements connecting the strut to the hub with a 15 mm spanner. - remove the bolt and disconnect the hub. - unscrew the upper fastening elements of the strut with a 19 mm spanner. - remove the shock absorber.

For reassembly, use the appropriate shock absorber support. The fifth step is to: - insert the shock absorber into the support; - remove the nut; The sixth step is to: - install the upper support and bearing; - tighten the strut rod bolt; - decompress the spring; - remove the strut and install the support in the wheel arch.

The seventh step is to: - mount the strut onto the hub and secure the support. - screw in the nut and remove the stabiliser bar from the shock absorber support, then screw in the fastening elements connecting the strut to the hub. - mount the wheel and insert the rubber adhesive seal, tightening the upper fastening elements of the shock absorber support with a 19 mm spanner.