Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the rear taillight on a Fiat Panda

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Tail light

In this very useful video tutorial, we are shown how to replace the rear taillight of a Fiat Panda, model 169. We begin the replacement procedure by opening the rear trunk of our car, then we unscrew the three screws that hold the taillight in place located on the inside of it. Once this is done, we carefully pull the taillight outwards to release its three plastic fastening clips as shown in the video, and then remove the rear light from its housing. Finally, we disconnect the wiring of the bulbs and then install a new taillight following the reverse procedure.

Posted on 15 August 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Light in a Fiat Panda
How to Replace the Rear Light in a Fiat Panda
Fiat Panda (1980-2003 / 141, MK 1) Before you start, open the boot of your Fiat Panda. Begin by unscrewing and removing the screws that secure the rear light to the vehicle. Then, dise…
Removing Rear Light of Fiat Panda 2
Removing Rear Light of Fiat Panda 2
Fiat Panda (2003-2012 / 169, MK 2) In today's video, see how to remove the rear light of a second-generation Fiat Panda in simple and quick steps. First, open the boot and unscrew the …
How to Replace the Rear Light in a Fiat Panda 169
How to Replace the Rear Light in a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) In this video tutorial, see how to replace the rear light in a Fiat Panda 169: the first step is to purchase a rear light from an authorised car part…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos