|
Do it yourself
| |||
| ||||
How to replace the rear discs and pads of a Ford Transit MK8.
Model: Ford Transit
MK 8
- Years:
2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024
Video tutorial
On the rear of the Ford Transit MK8, the brake disc is mounted directly on the wheel hub, which in turn contains the adjustable bearing. Therefore, to change the disc, we need to disassemble the entire half-shaft and remove the bearing. We remove the wheel, unlock and remove the half-shaft, after which we will find a large tightening nut with a diameter of 50mm that has a left-hand thread. There is a critical procedure to follow here; after installing the new disc and bearing, we tighten the adjusting nut to 88Nm to seat the components, then loosen the nut by half a turn, rotate the disc several times to seat the bearing rollers, and re-tighten the nut to a very light torque (30Nm). We will also need to replace the half-shaft seal, the ABS ring, and the half-shaft bolts. This is a task we can do ourselves only if we are very experienced and have the Ford workshop manual (and if we are prepared for a job that takes 3 to 4 hours per side); otherwise, it is better to have it done at a workshop.
Posted on 5 December 2025 by ScegliAuto
Related tutorials
Ford Transit
(2014-2024 /
MK 8)
In this guide, we will go through the instructions that will allow us to disassemble and replace the front brake discs of the Ford Transit. First, we…
Ford Transit
(2006-2014 /
MK 7)
To replace the rear brake pads on a Ford Transit, lift the wheel corresponding to the pads that need replacing so that it can be removed by loosening…
Ford Transit
(2006-2014 /
MK 7)
To replace the front brake pads of the Ford Transit, lift the vehicle so that the corresponding wheel is off the ground. Loosen all the relevant bolt…
Other guides you may be interested in
|
How to Remove the Rear Seat of a Hyundai Tucson?
To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.060
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |