Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the differential pressure sensor of the particulate filter on the Ford Kuga.

Model: Ford Kuga MK 1, C394 - Years: 2008, 2009, 2010, 2011, 2012
Part: Diesel particulate filter

See other generations:
Video tutorial

On the Ford Kuga, the differential pressure sensor of the DPF is connected to the particulate filter via two tubes: one for high pressure and one for low pressure. With the engine cold and the vehicle secured, locate the sensor on the engine compartment side (usually mounted on a bracket near the heat shield or battery).

Disconnect the electrical connector by pressing the tab, then detach the two tubes, carefully noting their orientation (the “HI” inlet towards the upstream point of the DPF, and the “LO” inlet towards the downstream point). Remove the screws from the bracket and free the component.

Install the new sensor on the bracket, reconnect the tubes respecting the exact HI/LO position, and snap the connector into place. Check that the tubes are not cracked or blocked; if they are hardened, replace them.

Start the engine and check for leaks and the integrity of the wiring. To restore alerts, enter diagnostic mode and reset the fault codes, then perform a reset of the DPF sensor's adaptive parameters if required.

After a short drive, check that the check engine light remains off and that the differential pressure values are within normal range.


Posted on 19 December 2025 by ScegliAuto


Related tutorials

How to Clean the Diesel Particulate Filter on the Ford Kuga?
How to Clean the Diesel Particulate Filter on the Ford Kuga?
Ford Kuga (2008-2012 / MK 1, C394) To clean the diesel particulate filter, it must be removed: it is located at the bottom of the vehicle, near the driver's side door. Using a 15mm spa…
How to replace the Ford Kuga joint filter
How to replace the Ford Kuga joint filter
Ford Kuga (2008-2012 / MK 1, C394) Today we will explain how to replace the Ford Kuga's Haldex joint filter on your own. But what is the Haldex joint? It is an electro-hydraulic system…
How to replace the cabin air filter of the 2017 Ford Kuga
How to replace the cabin air filter of the 2017 Ford Kuga
Ford Kuga (2012-2019 / MK 2, C520) If it is time to replace the cabin air filter of your second-generation Ford Kuga (2017) but you do not know how to do it, do not worry because below…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on the Opel Mokka?

To reset the tyre pressure warning light on the Opel Mokka, turn on the ignition by inserting the key into the ignition switch. Once the ignition is on, navigate through the menu that appears on the dashboard by pressing the MENU button on the lever to the left of the steering wheel. When the tyre pressure option appears, press and hold the SET/CLR button located on the same lever. This will reset the warning light, and you can then turn off the ignition.

Watch the video!


by ScegliAuto

More videos