Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Kuga
    4. : How do you clean the diesel particulate filter on the Ford Kuga?

Ford Kuga - Video tutorial

Model: Ford Kuga MK 1, C394 - Years 2008-2012
Part: Particulate filter
Operation: How do you clean the diesel particulate filter on the Ford Kuga?

In order to clean the particulate filter, it must be removed: it is located in the lower part of the machine, in correspondence with the driver's side door. With a 15 mm wrench you have to remove the sensor and also disconnect the differential pressure reading tubes. The filter can therefore be disconnected from the muffler by simply removing the nuts that fixed the two pieces. Once removed, the filter must be washed with a high pressure water jet: once it has been washed, it can be re-assembled together with all the pieces previously removed.


Posted on 20 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Kuga 2020-2027 - What problems does the particulate filter of the Ford Kuga present? Read Answer
    • Kuga 2012-2019 - What problems could the Ford Kuga particulate filter present? Read Answer
    • Kuga 2012-2019 - Why did the particle filter light come on in the Ford Kuga? Read Answer
    • Kuga 2008-2012 - What can cause the Ford Kuga engine warning light to come on? Read Answer
    • Kuga 2008-2012 - Where is the Ford Kuga's particulate filter located? Read Answer

How do you adjust the clutch cable on the Kia Picanto?

To be able to adjust the clutch cable of the Kia Picanto you need to open the hood so that you have access to the components inside the engine compartment: in order to reach the cable you will need to remove some components on the right side, such as the battery and the air filter. Below them you will find the clutch cable, which will have to be adjusted by screwing or loosening the bolt placed at the end of the cable. This will make the pedal harder or softer; after the adjustment, it will be possible to assemble all the components by closing the hood.

Watch the video!


by ScegliAuto

More videos