Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Headlight Bulb on a Ford Fusion

Model: Ford Fusion North America MK 2 - Years 2013-2020
Part: Headlight bulb

We will briefly go over the steps to remove and replace the low beam bulb in the front headlight of a Ford Fusion. First, open the hood of the vehicle and start by removing the plastic protective cap located behind the headlight; then disconnect the electrical connector and the bulb holder, removing the low beam bulb as shown in the video. At this point, install the new headlight bulb of the correct type and with the same base; check the light operation, and finally secure the protective cover.

Posted on 2 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Headlight Bulb on the Ford Fusion North America?
How to Replace the Front Headlight Bulb on the Ford Fusion North America?
Ford Fusion North America (2013-2020 / MK 2) To replace the front headlight bulb on the Ford Fusion North America, open the hood to loosen the two screws that secure the headlight from the top. …
How to Replace the Headlight Bulb on a Ford Fusion North America
How to Replace the Headlight Bulb on a Ford Fusion North America
Ford Fusion North America (2013-2020 / MK 2) If you need to replace a burnt-out headlight bulb, follow these instructions. After opening the hood, locate the headlight assembly with the burnt bu…
How to replace the rear light of a Ford Fusion
How to replace the rear light of a Ford Fusion
Ford Fusion North America (2013-2020 / MK 2) In the selected tutorial, we see how to replace a rear headlight of a Ford Fusion car. First, open the trunk of the vehicle to access the rear part o…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos