Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the engine oil in a Ford Puma

Model: Ford Puma MK 1 - Years 2019-2026
Part: Engine oil

To change the engine oil in a Ford Puma, position the car on a stable surface and lift it securely to access the underside of the engine. Place a collection tray under the oil sump and unscrew the filler cap in the engine bay. Then, remove the drain bolt located at the bottom of the sump and allow the used lubricant to completely drain out. Once draining is complete, replace the drain bolt, ensuring the seal is intact. Pour in the new oil through the designated filler neck, using the amount specified for the engine. Check the level with the dipstick or via the vehicle's electronic system and top up if necessary. Start the engine for a few moments, turn it off, and recheck the level, ensuring there are no leaks in the lower engine area.

Posted on 8 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the engine oil and oil filter of the Ford Puma 1.0 Ecoboost
How to replace the engine oil and oil filter of the Ford Puma 1.0 Ecoboost
Ford Puma (2019-2026 / MK 1) Today we will see the information related to the oil change and oil filter replacement of the Ford Puma 1.0 Ecoboost. First, we lift the car and star…
How do you change the battery of the key for the Ford Puma 2020?
Ford Puma (2019-2026 / MK 1) Very short video tutorial attached here to fully understand how to replace, in less than a minute, the battery of the key/remote of the Ford Puma and…
How to reset the oil light on the 2020 Ford Puma
How to reset the oil light on the 2020 Ford Puma
Ford Puma (2019-2026 / MK 1) In the following guide you will find all the various steps you need to follow if you intend to carry out the manual reset of the engine oil light on …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos