Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing the Front Spoiler

Model: Ford Fiesta Fiesta 6, MK 6, MK VI - Years 2008-2017
Part: Body

If possible, lift the vehicle to facilitate the disassembly operations. Remove the original spoiler at the end of the front bumper by reattaching the two screws underneath and securing the support bracket of the new spoiler to the one inside the wheel arch; also remove the pin located at the centre of the bumper. Bring the new spoiler close to the front bumper and trace the edges with a marker to mark the position where the adhesive tape will be applied. Clean the surface thoroughly where the adhesive will be applied, first apply the primer, remove the protective film from the adhesive, and position the spoiler ensuring it adheres perfectly, then secure it with the respective screws to the previously installed supports.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Spoiler on a Ford Fiesta?
How to Replace the Rear Spoiler on a Ford Fiesta?
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) If you intend to customise your vehicle by replacing the rear spoiler with an aftermarket model, follow the instructions below and refer to the video…
Installing LED Headlamp Bulb
Installing LED Headlamp Bulb
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) If you decide to replace the original headlamp bulbs, consider using LED bulbs instead of xenon kits. For this car model, you need to remove the head…
Installation of External Rear-View Mirror Glass
Ford Fiesta (2002-2008 / Fiesta 5, MK 5, MK V) Fitting the mirror glass into the external rear-view mirror is straightforward as it simply clips into place on the support. In this case, installati…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos