Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Remove the fuel filter on a Ford Focus

Ford Focus - Video tutorial

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Petrol filter
Operation: Remove the fuel filter on a Ford Focus

Does the fuel filter need to be changed? Let's see how the filter is removed from under the floor of the Focus. We lift the car on a column bridge, we identify the diesel filter as in the video. With a socket wrench we unscrew the locking pins located near the container (disconnect the cables and the various tubes from the filter) where the diesel filter is located. We remove the filter from under the floor (let's replace it with a new filter). Finally we reassemble the filter to the attached container of the diesel filter (we connect pipes and cables) and tighten the appropriate pins. We bring the car to the ground. We start the engine of the Focus.


Posted on 9 December 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Focus 2011-2018 - What is the location of the Ford Focus fuel filter? Read Answer
    • Focus 2004-2011 - How much is the petrol filter on the Ford Focus 1600 petrol? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos