Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Cabin Fan Resistor

Model: Ford Ranger MK 2 - Years: 1993, 1994, 1995, 1996, 1997
Part: Blower motor

See other generations:
Video tutorial

First, open the front bonnet. The cabin fan is located on the left side (when facing the engine) just below the windscreen, behind the windscreen washer reservoir.

You need to remove the reservoirs to allow access to the fan resistor, which is located at the bottom left. Unscrew the securing pins of the resistor and pull it out of its housing, disconnecting the plug attached to it (this operation may be quite difficult, so take care not to damage the plug itself).

Connect the new resistor to the plug and position it in its housing, tightening the relevant securing screws. Finally, refit the reservoir.


Updated on 5 February 2026 by ScegliAuto


Related tutorials

Replacing the Cabin Fan
Replacing the Cabin Fan
Ford Ranger (1993-1997 / MK 2) Open the front bonnet and ensure it is securely supported. To remove the cabin fan, it is necessary to detach the coolant and windscreen washer fluid…
How to Replace the Cabin Air Filter on a Ford Ranger?
How to Replace the Cabin Air Filter on a Ford Ranger?
Ford Ranger (2011-2023 / T6, P375, PX) To replace the cabin air filter on a Ford Ranger, locate the compartment where it is situated, which is under the front glove box. Start by opening t…
How to Recalibrate the Side Windows in the Ford Ranger Pickup?
How to Recalibrate the Side Windows in the Ford Ranger Pickup?
Ford Ranger (2011-2023 / T6, P375, PX) In this tutorial, you can see how to recalibrate the side windows in the Ford Ranger pickup, an extremely simple and quick operation to perform, for …

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos