Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Fiesta
    4. : Modification of engine air intake system with new filter

Ford Fiesta - Video tutorial

Model: Ford Fiesta MK VI, Fiesta 6, MK 6 - Years 2008-2017
Part: Air filter
Operation: Modification of engine air intake system with new filter

For the modification it is necessary to obtain the complete kit. Start by disconnecting the negative pole of the battery then disconnect the sensor connector located on the air duct. Completely disassemble the air filter box by removing all the pipes connected to it, then remove it completely from the engine compartment. Prepare the new accessory by carefully following the attached instructions. Insert the new filter holder in place of the old box and connect the various pipes. Insert the sensor into its new housing and secure it with the screws. Insert the new air filter, connect the sensor and reactivate the battery. Do a test to check the performance of the car.


Posted on 6 July 2023 by ScegliAuto



How to replace the air filter on a Ford Fiesta
Ford Fiesta (2002-2008 / MK V, Fiesta 5, MK 5) How to replace the engine air filter on Ford Fiesta? Let's see in this video how to proceed. We open the car door, pull up the engine compartment ope
How to replace the air filter on Ford Fiesta
Ford Fiesta (2008-2017 / MK VI, Fiesta 6, MK 6) How to replace the engine air filter on Ford Fiesta? Let's see in this video guide how to proceed with the replacement. Let's open the hood of the en
Air filter replacement for Ford Fiesta
Ford Fiesta (2017-2023 / MK VII, Fiesta 7, MK 7) To ensure a clean and constant flow of air to the engine of the Ford Fiesta, it is necessary to periodically change the filter on the intake circuit

    Frequently Asked Questions

    • Fiesta 2008-2017 - Where is the air filter located in the 2012 Ford Fiesta? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos