Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Rear Headlamp Bulb

Model: Ford Ranger MK 2 - Years 1993-1997
Part: Tail light bulb

Remove the fixing screws of the rear lamp, located at the top of the driver's cabin, disconnect the connector attached to it and connect it to the new lamp (ensure the new lamp is complete with bulbs; otherwise, transfer those from the old lamp or install new ones).
Position the lamp in its housing, ensuring the gasket adheres perfectly along the edges, and secure it by tightening the relevant fixing screws (do not exceed the torque as this may damage the plastic of the lamp itself).
Finally, check that all bulbs are functioning correctly.

Updated on 5 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Tailgate Cable
Replacement of Tailgate Cable
Ford Ranger (1993-1997 / MK 2) To replace the cable, you only need a screwdriver and a ratchet spanner. The retaining screws for the cable are accessible on the tailgate and the bo…
Replacement of Clogged Fuel Filter
Replacement of Clogged Fuel Filter
Ford Ranger (1993-1997 / MK 2) The fuel filter is located at the entrance of the fuel filler neck. To replace it, you need to remove the two screws holding the filler neck, which i…
Replacement of the External Wing Mirror
Replacement of the External Wing Mirror
Ford Ranger (1993-1997 / MK 2) In this video, the procedure for replacing an external wing mirror (driver side) of a Ford Ranger is shown. Start by detaching the top part of the wi…

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos