Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Reflector on Ford Fiesta

Model: Ford Fiesta Fiesta 6, MK 6, MK VI - Years 2008-2017
Part: Tail light

In any maintenance operation on a car (and, therefore, in this case as well), it is advisable to place your Ford Fiesta on a flat surface or on a lift. This precaution is recommended (if not necessary) to ensure the safety of the operator and allow them to work in safe and stable conditions. Now, access the part to be replaced from the inside of the bumper, and using the appropriate spanner, unscrew the screw (located at the outer corner of the reflector). Once done, simply push from the outside towards the inside (from the corner facing inwards) to remove the reflector and replace it with the new one. The assembly operations are the same as shown in the images, performed in reverse.

Updated on 3 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Reflector on Ford Fiesta
Replacing Reflector on Ford Fiesta
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) Is the reflector on your Ford Fiesta damaged? Here’s how to remove it. Open the compartment where the reflector is mounted, specifically at the rear …
How to Remove the Rear Reflector Lamp on the Ford Fiesta?
How to Remove the Rear Reflector Lamp on the Ford Fiesta?
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) In this tutorial, you will see how to remove the small rear reflector lamp of the Ford Fiesta MK6. First, use a Torx key to remove the lower screw of…
How to Replace the Rear Fog Light on a Ford Fiesta
How to Replace the Rear Fog Light on a Ford Fiesta
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) In this short and simple guide, learn how to remove and replace the reflector or rear fog light on a Ford Fiesta. To access the fog light on the rear…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos